Reef Advantage Calcium™ is a non-caustic (pH 8.3–8.6) optimized blend of ionic calcium designed to restore and maintain calcium to levels found in natural seawater. Calcium and carbonates are essential to all coral growth. If either becomes deficient, coral growth will cease, followed by a rapid decline in coral health.
Reef Advantage Calcium™ also includes magnesium and strontium in amounts proportionate to typical utilization ratios (100:5:0.1, Ca:Mg:Sr). This allows one to maintain these two important elements while maintaining calcium. Unlike limewater (kalkwasser), Reef Advantage Calcium™ does not have a caustic pH and will not deplete magnesium. Used as directed, it will not deplete alkalinity.
Directions
Beginner
Use 5 g (1 level teaspoon) per 150 L (40 US gallons) twice a week. For precise dosing, use the Seachem Digital Spoon Scale. Dissolve in at least 250 mL (1 cup) of freshwater. Check calcium every 2 weeks and adjust amount or frequency accordingly.
Advanced
Check calcium level (use Reef Status™ Calcium to test magnesium levels), then follow addition regimen above until calcium is adjusted to 380–420 mg/L. Each 5 g/150 L will raise calcium by about 12 mg/L. Quantity or frequency can be adjusted, but do not exceed 10 g/150 L per day. Thereafter, use as required to maintain calcium.
Expert
After determining the calcium consumption rate, set up a continuous drip system. Use the following formula (or skip the math and use our Dosage Calculator) to determine how much to add to your top-off water: m=vc/400 (m=grams to add to top off water, v=volume of tank in liters, c=amount to raise calcium in mg/L). [For reference: 1 gallon=3.8 liters, 5 g=1 teaspoon].
DO NOT OVERDOSE: Excess calcium may enhance the loss of carbonate alkalinity. Do not directly mix with any carbonate supplement. Best if calcium & carbonate additives are added on alternate days or at least 30 minutes apart.
Adjusts pH to neutral (pH 7.0) from either a low or high pH
Softens water by precipitating calcium and magnesium
Removes chlorine, chloramine, or ammonia
Natural organic waste management
Rapidly and safely eliminates sludge and detritus
Helps increase water clarity
Marine and freshwater
Adjusts pH to the acidic range (4.5‑6.8)
Softens water by precipitating calcium and magnesium
Use with Neutral Regulator® to target a pH
Adjusts pH to 6.5
Creates ideal environment for Asian Arowanas
Softens water
Enhances immunity
Adjusts pH to the alkaline range (7.1 – 7.6)
Supports the establishment of the optimal environment for all alkaline acclimated species
Use with Neutral Regulator® to target a pH
Content
Overview
Reef Advantage Calcium™ is a non-caustic (pH 8.3–8.6) optimized blend of ionic calcium designed to restore and maintain calcium to levels found in natural seawater. Calcium and carbonates are essential to all coral growth. If either becomes deficient, coral growth will cease, followed by a rapid decline in coral health.
Reef Advantage Calcium™ also includes magnesium and strontium in amounts proportionate to typical utilization ratios (100:5:0.1, Ca:Mg:Sr). This allows one to maintain these two important elements while maintaining calcium. Unlike limewater (kalkwasser), Reef Advantage Calcium™ does not have a caustic pH and will not deplete magnesium. Used as directed, it will not deplete alkalinity.
Directions
Beginner
Use 5 g (1 level teaspoon) per 150 L (40 US gallons) twice a week. For precise dosing, use the Seachem Digital Spoon Scale. Dissolve in at least 250 mL (1 cup) of freshwater. Check calcium every 2 weeks and adjust amount or frequency accordingly.
Advanced
Check calcium level (use Reef Status™ Calcium to test magnesium levels), then follow addition regimen above until calcium is adjusted to 380–420 mg/L. Each 5 g/150 L will raise calcium by about 12 mg/L. Quantity or frequency can be adjusted, but do not exceed 10 g/150 L per day. Thereafter, use as required to maintain calcium.
Expert
After determining the calcium consumption rate, set up a continuous drip system. Use the following formula (or skip the math and use our Dosage Calculator) to determine how much to add to your top-off water: m=vc/400 (m=grams to add to top off water, v=volume of tank in liters, c=amount to raise calcium in mg/L). [For reference: 1 gallon=3.8 liters, 5 g=1 teaspoon].
DO NOT OVERDOSE: Excess calcium may enhance the loss of carbonate alkalinity. Do not directly mix with any carbonate supplement. Best if calcium & carbonate additives are added on alternate days or at least 30 minutes apart.
Overview
Neutral Regulator® adjusts pH to neutral (pH 7.0) from either a low or high pH and maintains it there. It softens water by precipitating calcium and magnesium while removing any chlorine, chloramine, and detoxifying ammonia. The use of Neutral Regulator® makes other conditioning unnecessary. To lower pH below 7.0 use Neutral Regulator® with Acid Regulator™ (or Discus Buffer®). To raise pH above 7.0 use with Alkaline Regulator™. All of these products will enhance and stabilize the freshwater aquarium environment. For further freshwater environment enhancement, use Fresh Trace™ to restore the proper level of trace elements and feed NutriDiet® Tropical Flakes for thriving, healthy freshwater community fish.
Contains phosphate buffers and conditioning agents. Safe for all freshwater fish acclimated to neutral pH.
Directions
Use 5 g (1 level teaspoon) for every 40–80 L (10–20 US gallons) once or twice a month (or as necessary to maintain a pH of 7.0.) Neutral Regulator® may be be initially used daily in cases of high alkalinity until 7.0 is established. It may be added directly to the aquarium at any time. Ideally, it should be used when adding or changing water by dissolving in the replacement water. For precise dosing, use the Seachem Digital Spoon Scale.
Overview
Pristine™ uses bio-augmentation, a non-chemical and natural method, to improve water quality. It provides bacteria that break down excess food, waste and detritus in freshwater and marine systems. It will also reduce excess nutrients (e.g. ammonia, nitrates, and nitrites) that may fuel the growth of nuisance and disease-causing organisms. Pristine™ increases water clarity and promotes overall better health for the aquatic environment.
The species of bacteria in Pristine™ are a unique blend, specifically developed for hardiness and their ability to adapt to a wide variety of environmental conditions.
The bacteria species in Pristine™ thrive in fresh or salt water and can utilize a wide range of organic compounds, including fats that can cause unsightly films. Unlike traditional nitrifying bacteria, this bacterial blend can adapt to harsh or low oxygen environments and continue to multiply and improve water conditions. Biopolymers produced by established bacterial colonies trap particulates and increase water clarity.
Directions
Shake well before use. Turn off UV/ozone. Use 1 capful (5 mL) for each 40 L (10 US gallons). Then use a maintenance dose of 1 capful (5 mL) per 80 L (20 US gallons) with additions of livestock or the disruption of the biofilter through cleaning or medications. Antibiotics should be removed with fresh carbon and a water change before adding bacteria. Allow 2 or 3 days for the bacteria to become established before using UV sterilizers or ozone. Recurring problems with high nutrients can indicate overstocking, overfeeding or inadequate filtration.
Overview
Acid Regulator™ adjusts pH to the acidic range (4.5–5.5) and softens water by precipitating calcium and magnesium. Acid Regulator™ supports the establishment of the optimal environment for all acid acclimated species (e.g. neons and other tetras, etc.). For further freshwater environment enhancement, use Fresh Trace™ to restore the proper level of trace elements and feed NutriDiet® Tropical Flakes for thriving, healthy freshwater community fish.
Contains phosphate buffers and conditioning agents. Safe for all freshwater fish acclimated to acid pH.
Directions
Use 1 level teaspoon (5 g) for every 40 L (10 US gallons) daily until intended pH is reached. For precise dosing use the Seachem Digital Spoon Scale. Thereafter, use once a month or with water changes as required to maintain pH. To raise pH, use Neutral Regulator®.
To target a particular pH use in combination with Neutral Regulator® following the chart. This chart assumes the use of unbuffered water (RO or DI). If water is already buffered use the chart as a starting guide. Use Prime® to dechlorinate tap water before doing a water change.
To target a particular pH use in combination with Neutral Regulator® following the chart
Neutral Regulator
Acid Regulator
pH
1
1
6.8
1
2
6.4
1
3
6.2
1
4
6.1
1
6
6.0
1
9
5.8
Overview
Arowana Buffer™ adjusts pH to 6.5 from either a low or high pH and maintains it there for 2–4 weeks. It safely softens water by precipitating calcium and magnesium. It also supports the ability of arowanas to resist infections. It is the buffer of choice for conditioning water for Asian Arowanas.
Directions
Use 1 level teaspoon for every 40 L (10 gallons) once or twice a month (or as necessary to maintain a pH of 6.5.) Arowana Buffer™ may be initially used daily in cases of high alkalinity until 6.5 is established. It may be added directly to the aquarium at any time. Ideally, it should be used when adding or changing water by dissolving in the replacement water.
Overview
Alkaline Regulator™ adjusts pH to the alkaline range (7.1–7.6) and supports the establishment of the optimal environment for all alkaline acclimated species (e.g. bosemani, various other rainbows etc.). For further freshwater environment enhancement, use Fresh Trace™ to restore the proper level of trace elements and feed NutriDiet® Tropical Flakes for thriving, healthy freshwater community fish.
Contains phosphate buffers and conditioning agents. Safe for all freshwater fish acclimated to alkaline pH.
Directions
Use 1 level teaspoon (5 g) for every 40–80 L (10–20 US gallons) daily until intended pH is reached. Thereafter, use once a month or with water changes as required to maintain pH. To lower pH, use Neutral Regulator®.
To target a particular pH use in combination with Neutral Regulator® following the chart. This chart assumes the use of unbuffered water (RO or DI). If water is already buffered use the chart as a starting guide. Use Prime® to dechlorinate tap water before doing a water change.
To target a particular pH use in combination with Neutral Regulator® following the chart
