Discus Buffer® helps to replicate the ideal Discus environment (low pH & low GH (General Hardness)). Discus Buffer® will lower pH and keep it lowered. Discus Buffer® also softens water by precipitating calcium and magnesium. Use Discus Trace™ to restore the proper level of trace elements and feed NutriDiet® Discus Flakes for thriving, healthy Discus.
Neutral Regulator® and Discus Buffer® can be used in combination to achieve a desired pH when performing water changes or adding top off water. The ratio chart below is designed for RO water where there is generally no buffering capacity.
Contains phosphate buffers and conditioning agents. Safe for all freshwater fish acclimated to acid pH.
Directions
Use 1 level teaspoon (5 g) for every 40-80 L (10-20 US gallons) daily until intended pH is reached. Thereafter, use once a month or with water changes as required to maintain pH.For precise dosing use the Seachem Digital Spoon Scale. To raise pH, use Neutral Regulator®. To target a particular pH use in combination with Neutral Regulator® following the chart. This chart assumes the use of unbuffered water (RO or DI). If water is already buffered use the chart as a starting guide. Use Prime® to dechlorinate tap water before doing a water change.
To target a particular pH use in combination with Neutral Regulator® following the chart
Increases pH with no impact on carbonate alkalinity
New tank stabilization system for marine and freshwater
Rapidly and safely establishes bio-filter
Prevents "New Tank Syndrome"
Trace elements supplement for Cichlids
Contains only those elements actually demonstrated* to be required by fish
Detoxifies ammonia for up to 72 hours
Ideal for emergency situations
More effective than any other ammonia-binding product
Most concentrated product on the market
Content
Overview
Discus Buffer® helps to replicate the ideal Discus environment (low pH & low GH (General Hardness)). Discus Buffer® will lower pH and keep it lowered. Discus Buffer® also softens water by precipitating calcium and magnesium. Use Discus Trace™ to restore the proper level of trace elements and feed NutriDiet® Discus Flakes for thriving, healthy Discus.
Neutral Regulator® and Discus Buffer® can be used in combination to achieve a desired pH when performing water changes or adding top off water. The ratio chart below is designed for RO water where there is generally no buffering capacity.
Contains phosphate buffers and conditioning agents. Safe for all freshwater fish acclimated to acid pH.
Directions
Use 1 level teaspoon (5 g) for every 40-80 L (10-20 US gallons) daily until intended pH is reached. Thereafter, use once a month or with water changes as required to maintain pH.For precise dosing use the Seachem Digital Spoon Scale. To raise pH, use Neutral Regulator®. To target a particular pH use in combination with Neutral Regulator® following the chart. This chart assumes the use of unbuffered water (RO or DI). If water is already buffered use the chart as a starting guide. Use Prime® to dechlorinate tap water before doing a water change.
To target a particular pH use in combination with Neutral Regulator® following the chart
Neutral Regulator
Discus Buffer
pH
1
1
6.8
1
2
6.4
1
3
6.2
1
4
6.1
1
6
6.0
1
9
5.8
Overview
Safe™ is the complete and super-concentrated dry conditioner for both fresh and salt water. Safe™ removes chlorine, chloramine and detoxifies ammonia, nitrite, and nitrate. It is non-acidic and will not impact pH. A further bonus for the reef hobbyist—Safe™ will not over-activate skimmers.
Safe™ may be used during tank cycling to alleviate ammonia/nitrite toxicity. It contains a binder which renders ammonia, nitrite, and nitrate non-toxic, allowing the biofilter to more efficiently remove them. Use at start-up and whenever adding or replacing water. When transporting or quarantining fish, use Seachem StressGuard™. When adding new fish, use Stability®. Both are ideal for use with Safe™.
Directions
May be added to aquarium directly, but better if added to new water first. If adding directly to aquarium, base dose on aquarium volume. For exceptionally high chloramine concentrations, a double dose may be used safely. To detoxify nitrite and nitrate in an emergency, up to 4 times normal dose may be used. If temperature is > 30 °C (86 °F) and chlorine or ammonia levels are low, use a half dose.
50 gram
Use 200 mg of Safe™ (included scoop) per each 200 L (50 US gallons) as needed to reduce chlorine and chloramine or per 50 L (13 US gallons) for ammonia.
NOTE: These directions supersede all other prior packaging.
All other sizes
Use 1.25 g (1/4 tsp.) for every 1,250 L (300 US gallons) as needed to reduce chlorine and chloramine or use 1.25 g (1/4 tsp.) for every 300 L (75 US gallons) for ammonia. For precise dosing, use the Seachem Digital Spoon Scale.
NOTE: These directions supersede all other prior packaging.
Overview
Reef Kalkwasser™ is a pure calcium hydroxide with unsurpassed purity and solubility characteristics. Calcium hydroxide is used to prepare limewater (kalkwasser) solutions that will maintain calcium concentrations at natural seawater levels. Kalkwasser solutions maintain calcium directly and carbonate alkalinity indirectly. However, its capacity to perform these functions is dependent on evaporation rate and CO2 concentration. If these two factors are insufficient you can provide additional calcium with Reef Advantage Calcium™, Reef Complete™, or Reef Calcium™, and carbonate alkalinity with Reef Builder™ or Reef Carbonate™ (do not mix these directly with a kalkwasser solution).
While Reef Kalkwasser™ is a high purity and economical limewater mix, the beginner, or someone with not as much time to devote to their system, may prefer to use other less involved methods for maintaining proper ionic concentration levels.
Directions
Never add this product directly to the tank. Add 3 g (1 teaspoon) to 4 L (1 US gallon) of water and mix to dissolve. If using pure water, a fully saturated solution is prepared by adding 6 g (2 teaspoons) to 4 L (1 US gallon). Drip this solution into tank. Monitor pH and carbonate alkalinity. Adjust rate of addition to maintain a stable pH (8.3–8.4). Notes: Adding 4 L (1 US gallon) of a saturated kalkwasser solution to 150 L (40 US gallons) will raise calcium by 24 mg/L. Always use the clear supernatant (top solution) only and do not allow undissolved material to enter the aquarium. Keep this container tightly closed when not in use and minimize solution/air contact to avoid calcium carbonate formation/precipitation.
Overview
Stability® will rapidly and safely establish the aquarium biofilter in freshwater and marine systems, thereby preventing the #1 cause of fish death: "new tank syndrome". Stability® is formulated specifically for the aquarium and contains a synergistic blend of aerobic, anaerobic, and facultative bacteria which facilitate the breakdown of waste organics, ammonia, nitrite, and nitrate. The bacteria employed by Stability® are non-sulfur fixing and will not produce toxic hydrogen sulfide. Stability® is completely harmless to all aquatic organisms as well as aquatic plants, thus there is no danger of over use.
Stability® is the culmination of nearly a decade of research and development and represents the current state of the art in natural biological management.
The bacteria used in competing products are inherently unstable. The conditions necessary for their growth and development fall into a very narrow range of temperatures, pH, organic loads, etc. When any of these parameters are not strictly within the proper range, the bacterial culture quickly crashes and dies. Stability® is not limited this way. The necessary conditions for the growth of Stability's™ bacteria strains encompass a very broad range. When other bacteria begin to die off (usually from high organic loads caused by the undetected death of an organism), Stability™ simply becomes more effective.
Directions
Shake well before use. Turn off UV/ozone. Use 1 capful (5 mL) for each 40 L (10 US gallons) on the first day with a new aquarium. Then use 1 capful for each 80 L (20 US gallons) daily for 7 days. Fish and other aquatic species may be introduced at any time as long as dosage is maintained for 7 days. For optimum biofilter performance use 1 capful for each 80 L (20 US gallons) once a month or with each water change and whenever introducing new fish or whenever medicating an aquarium. Product shelf life is 4 years from date of manufacture.
Stability® should ideally be used in conjunction with biological filtration such as Seachem Matrix™. For emergency ammonia control, use Seachem AmGuard™.
Overview
Cichlid Trace™ supplies a broad range of trace elements demonstrated* to be necessary for proper fish health and growth. Unlike terrestrial animals, fish obtain nutrients from both their food and environment. Trace elements are normally depleted by utilization, oxidation and precipitation, thus it is important to restore them on a regular basis. Cichlid Trace™ contains only those elements actually demonstrated* to be required by fish.
*Nutrient Requirements of Fish, National Academy of Sciences, pp. 16-21,1993.
Directions
Use 1 capful (5 mL) for every 80 L (20 US gallons) twice a week. Feed NutriDiet® Cichlid Flakes for optimal fish health.
Overview
AmGuard™ safely, rapidly and efficiently detoxifies toxic free ammonia. It is safe to use during tank cycling and is ideal for treating emergency situations. AmGuard™ is the strongest liquid ammonia binder on the market. It works within minutes to detoxify free ammonia, and it doesn’t degrade for nearly 72 hours. That’s at least twice as long as our competitors’ products. Unlike competing products, AmGuard™ converts it into a safe, non-toxic form that is readily removed by the tank’s biofilter. It does not alter pH.
Ammonia can exist in two forms: free and ionized. It is only the free form that is toxic. Traditional ammonia test kits convert all ammonia to free ammonia by raising pH to 12–14; at this pH AmGuard™ cannot function and thus a false positive reading will result. For long term ammonia control, use Seachem Stability® and Matrix™. Use Ammonia Alert® or MultiTest™ Free & Total Ammonia to directly monitor levels of free ammonia. AmGuard™ also removes chlorine and chloramines.
Directions
Use 1 capful (5 mL) for every 200 L (50 US gallons) daily or as needed to reduce ammonia.
ADVANCED: If you have an Ammonia Alert® that is reading “Alert”, then use 1 capful (5 mL) for every 400 L (100 US gallons) daily. If it reads “Alarm”, then use 1 capful for every 200 L (50 US gallons) daily. If it reads “Toxic”, then use 1 capful for every 80 L (20 US gallons) daily.
EXPERT: If using our MultiTest™ Free & Total Ammonia test kit, use 1 capful (5 mL) for every 40 L (10 US gallons) to remove 1 mg/L (ppm) of free ammonia. Alternatively you may employ the following formula for a variety of ammonia and water levels: 0.125AV=m (for volume in liters) or 0.5AV=m (for volume in gallons). A=ammonia concentration in mg/L, V=the volume of water being treated and m=the volume of AmGuard™ to use in mL. For example, to remove 1 mg/L of ammonia in 100 gallons you would use 0.5*1*100=50 mL.
If water temperature is above 30 °C (86 °F) do not use.
