Large surface area of diffuser disc ideal for high volumes of CO2 gas
Built in bubble counter makes the use of a separate bubble counter unnecessary
Simple and easy to use
This is a new type of glass washing brush with a flexible wire. Even New Lily Pipe is easily cleaned. Small brush that fits curved pipe and flexible coil-like wire are equipped.
Ideal for aquarium airline or CO2 tubing
10 mm size is suitable for rimless aquariums
Great for use with CO2 injection systems or bubblers
Moss Cotton is a special thread to tie and fix moss on driftwood. In a quite dark green color similar to that of Willow moss and it will naturally biodegrade after Willow moss has taken root to the driftwood or rock.
Content
Overview
The Spiral Bubble Counting Diffuser is a pollen style CO2 diffuser that connects to CO2 injection systems to easily disperse CO2 gas into the planted aquarium. The built-in spiral bubble counter allows for easy monitoring of the rate of CO2 injection. The inclusion of a bubble counter in the diffuser makes the use of a bubble counter on the CO2 tank or in-line unnecessary. The Spiral Bubble Counting Diffuser has a 30 mm disc.
Compatible with 6 mm (1/4") - Standard Airline Tubing. Suction cup included.
Directions
Rinse glassware with warm water. Attach suction cup and desired tubing (Compatible with 6 mm (1/4") - Standard Airline Tubing) to the diffuser.
To attach tubing to glassware, wet the inside of the tubing with water at the attachment point and carefully slide tubing over glass. The use of other lubricants is not advisable as these usually make the tubing slide off of the glassware too easily. To avoid breakage when removing tubing, do not pull tubing off of glassware. Instead, cut tubing carefully along the attachment length to release the glassware.
Mount your diffuser using the suction cup(s). It should be positioned low in the aquarium. When removing or repositioning the diffuser, pull by the suction cup(s) rather than the glass to avoid breakage.
Install check valve (not included) inline with tubing outside of the aquarium
Once securely mounted, turn on CO2. Observe bubble count and adjust CO2 to desired flow rate.
Overview
The 10 mm glass U Tube allows you to easily run airline (preferably silicone) for CO2 or for general air supply over the rim of the aquarium without bending or creasing. Made of strong clear glass, which minimizes visibility of tubing.
Compatible with 6 mm (1/4") - Standard Airline Tubing.
Directions
Rinse glassware with warm water. Trim and attach desired tubing (Compatible with 6 mm (1/4") - Standard Airline Tubing).
To attach tubing to glassware, wet the inside of the tubing with water at the attachment point and carefully slide tubing over glass. The use of other lubricants is not advisable as these usually make the tubing slide off of the glassware too easily. To avoid breakage when removing tubing, do not pull tubing off of glassware. Instead, cut tubing carefully along the attachment length to release the glassware.
Install check valve, if desired, (not included) inline with tubing outside of the aquarium
Mount your U Tube over the rim of your aquarium in the desired location
Moss Cotton is a special thread to tie and fix moss on driftwood. In a quite dark green color similar to that of Willow moss and it will naturally biodegrade after Willow moss has taken root to the driftwood or rock.
